Jacks R Better Bear Mountain Bridge Hammock set up between two trees at a campsite

Bear Mountain Bridge Hammock

$249.00
Skip to product information
Jacks R Better Bear Mountain Bridge Hammock set up between two trees at a campsite
1/2

Bear Mountain Bridge Hammock

$249.00

The Jacks 'R' Better Bear Mountain Bridge Hammock is a true lay flat, sleep straight hammock. It achieves these notable results by departing from the common "gather end" design to utilize a suspension bridge technique. The hammock takes its name from the suspension bridge over the Hudson River that carries the Appalachian Trail. When the Bear Mountain Bridge was completed in 1924 it was the largest suspension bridge in the world. This is the lowest point of the entire Appalachian Trail at 127 feet above sea level.

The JRB Bear Mountain Bridge Hammock is constructed of 70D rip stop nylon material and high strength polypropylene webbing. It will comfortably accommodate individuals up to 6 foot 3 inches tall and up to 250 pounds.

The hammock comes complete with an attached bug net made of no-see-um netting that is zippered on three sides with a double pull zipper. It can be unzipped and tied back if desired when there is no bug threat. There are two personal gear pockets, one on each end wall of the hammock. And for added comfort we've included a re-usable, 14" x 10", 0.6 ounce, inflatable pillow.

For bottom insulation, use the loops on each corner to attach the Mt Washington or Greylock series of under quilts or any of the standard (78"x48") JRB quilts as an under quilt; or the built in 26 inch wide pad pocket that will accommodate most camping pads.

Suspension Options:

No Suspension - Use a suspension you already have or DIY your own suspension solution. The primary ring, secondary rings, and secondary straps are still in place so just attach your chosen suspension to the primary ring and you are ready to hang.

Hammock End Straps and Tri-Glide Set - Ultra-light hammock suspension set. No knots or lashings are required. Two 10' long, 1 inch wide, 700 pound, polypropylene web straps with 1.5 inch loops in one end and two JRB Tri-Glides. Each strap weighs 2.1 oz. Each tri-glide weighs 0.3 oz. Total weight for the set is 4.8 oz.

CAUTION: The aluminum spreader bars are intended to withstand compression force along their long axis. Lateral stresses will cause the bars to fail and bend. DO NOT try to adjust your body position by pulling on the spreader bars. Instead grab the sides of the hammock. Jacks 'R' Better does not recommend hanging packs or other gear from the spreader bar itself as this places unnecessary stress on the spreader bar.

You may also like